Connectors, Button and LEDs

Indoor version

Connectors

1. LoRa antenna
2. Reset button
3. LED WWAN: Information about the mobile LTE/4G/3G network connection
4. LED WLAN: Information about the Wi-Fi connection
5. LED LoRa: Information about the connection from LoRa to the Internet
6. LED PWR: Device power status
7. Power input, USB micro
8. USB connector for additional devices
9. Ethernet / Power
10. External LTE antenna

Note

Availability of connector or interface depends on device variant

LED status information

Typical LED behavior:

LED	Description	solid	flashing	off
LTE/WWAN	mobile network available	connected	data transmit	not available
WLAN	WiFi activity		Transmission activity	off
LoRa	LoRa connectivity	connected		connection not established
PWR	Power supply	device is powered		device not powered

The gateway is running properly if:

• PWR LED is solid green
• LoRa LED is solid green (see note below)

Important

LoRa LED operation depends on LNS (e.g. TTI/TTN) in combination with some specific gateway firmware version and/or configurations.

LTE/WWAN LED behaviour depend on the LTE card equipped in the gateway.

Button

The reset button allows resetting the device and is also used to update the device firmware or perform a factory reset.

To reset the device, press and release the reset button.

Outdoor version

Connectors

1. Air pressure compensation
2. Power Indicator
3. Power Connector (optional)
4. Ethernet Connector (optional)
5. LTE antenna (optional)
6. LoRa antenna

Note

Availability of connector or interface depends on device variant

LED status information

Power LED is a solid green after power on.

Button

On the outdoor version, the reset button is not accessible from the outside. If you open the housing, you have access to button on the gateway base board. Refer to button behaviour of an indoor version for details.

Warning

Opening the outdoor housing might compromise water ingress protection